Does AFM harness connector look like this?
#1
Registered User
Thread Starter
Join Date: Sep 2016
Location: Northern MI
Posts: 28
Likes: 0
Received 0 Likes
on
0 Posts
Does AFM harness connector look like this?
Hi! I have a 94 4runner 3.0. I was wondering if my connector is missing a metal connection(3rd one from the left) or if the connector is just like this from the factory. Please verify and help me please!!!
Last edited by sam_KOR; 09-24-2016 at 10:27 AM.
#3
Registered User
Thread Starter
Join Date: Sep 2016
Location: Northern MI
Posts: 28
Likes: 0
Received 0 Likes
on
0 Posts
Thank you for verifying that this is correct.
You are correct. I haven't figured it out yet.. and thank you for your previous advice on FP and b+ jumping. It totally worked and the pump was working which means the COR is not operational.
I'm checking compressions in each cylinder now. I know.. I should have done that first but I doubt compression is the problem. I'm leaning more towards TPS issue and a defective AFM. I was testing the AFM connectors and all the resistance on them were either 0 or something way off from what this video had:
.
Would you please give me some advice what might go wrong? You are my only hope man..
You are correct. I haven't figured it out yet.. and thank you for your previous advice on FP and b+ jumping. It totally worked and the pump was working which means the COR is not operational.
I'm checking compressions in each cylinder now. I know.. I should have done that first but I doubt compression is the problem. I'm leaning more towards TPS issue and a defective AFM. I was testing the AFM connectors and all the resistance on them were either 0 or something way off from what this video had:
Would you please give me some advice what might go wrong? You are my only hope man..
Last edited by sam_KOR; 09-24-2016 at 02:54 PM.
Thread
Thread Starter
Forum
Replies
Last Post
shadowstewie
Newbie Tech Section
3
09-15-2016 05:03 AM