Shop Recommendations NorthWest Tennessee for Tacoma CV axle conversion to manual hubs
02-22-2011 | 07:52 AM
#1
Thread Starter
Registered User
Joined: Feb 2011
Posts: 1
Likes: 0
From: Dyersburg, TN
Shop Recommendations NorthWest Tennessee for Tacoma CV axle conversion to manual hubs
Anybody know of a shop in Northwest TN that could do a turnkey hubs conversion on a 2002 Tacoma dbl cab TRD? I just do not have time or a location to do the work right now and am about ready to dump the TRD.
Front diff rebuilt last spring-bearings severely worn at 60K. CV axles both bad since then. 2&1/2" suspension lift changed CV axle angles-possibly caused excess wear? Need more lift, but axle angles too severe when running all the time.
Truck is weekend hunting/fishing truck- not daily driver. Has only 67K in over 9 years. Less than 2k of 4X4-off-road and snow/ice on road.
What was Toyota thinking- save/make money by designing truck to wear out parts for no rational reason?
Front diff rebuilt last spring-bearings severely worn at 60K. CV axles both bad since then. 2&1/2" suspension lift changed CV axle angles-possibly caused excess wear? Need more lift, but axle angles too severe when running all the time.
Truck is weekend hunting/fishing truck- not daily driver. Has only 67K in over 9 years. Less than 2k of 4X4-off-road and snow/ice on road.
What was Toyota thinking- save/make money by designing truck to wear out parts for no rational reason?
Thread
Thread Starter
Forum
Replies
Last Post
FS[PacSouthWest]: 2- 8"3rd members:4.88 ratchet lockers,new setup kit, rear axle rebuild kit,diff armor
jerusry
Axles - Suspensions - Tires - Wheels
1
10-19-2015 05:28 PM
crashburnoveride
86-95 Trucks & 4Runners
1
07-10-2015 06:39 AM
