Suggestions on 3rd Gen Upper Control Arms
#21
Originally Posted by RIPPER
You must be Navy! AF (well here at Seymour at least) sucks for our hobby shops. I went to install them Sat and they didn't have the tools to pull the A-arm off.
#22
Registered User
Thread Starter
Join Date: Jan 2005
Location: NC
Posts: 80
Likes: 0
Received 0 Likes
on
0 Posts
LMAO....you think AF has the best equipment? LOL I shouldn't have to remind you that ALL military equipment is procured through the LOWEST BIDDER. Thats right Mrs. America, Johnny gets to fly a jet built by the cheapest party that put in a bid. But mind you the same people pay $10,000 for a hammer and toilet seat as well!!!!
Well back to the story at hand; I went to Down East Off Road in Wilson where Rob(owner) and Ben promptly installed new BJ and upper A-arms as well installed new 315/75/16 tires. Kudos to Rob and the gang (although they are jeepsters) for the top notch workmanship. They had to use a torch to remove the BJ on the right side, with a sledge hammer. Sucker was on there!!
Well back to the story at hand; I went to Down East Off Road in Wilson where Rob(owner) and Ben promptly installed new BJ and upper A-arms as well installed new 315/75/16 tires. Kudos to Rob and the gang (although they are jeepsters) for the top notch workmanship. They had to use a torch to remove the BJ on the right side, with a sledge hammer. Sucker was on there!!
#24
Registered User
Join Date: Feb 2005
Location: Portland, OR
Posts: 326
Likes: 0
Received 0 Likes
on
0 Posts
Anyone want some stock Arms??? I'll make an awesome deal... PM me
I love my Total Chaos Arms... No issues yet. Lots a travel... look spiffy. No issues with alignment.
I love my Total Chaos Arms... No issues yet. Lots a travel... look spiffy. No issues with alignment.
#26
Contributing Member
Join Date: Jun 2004
Location: Richmond, Va
Posts: 4,218
Likes: 0
Received 0 Likes
on
0 Posts
Originally Posted by RIPPER
Well back to the story at hand; I went to Down East Off Road in Wilson where Rob(owner) and Ben promptly installed new BJ and upper A-arms as well installed new 315/75/16 tires.
Thread
Thread Starter
Forum
Replies
Last Post
FS[PacSouthWest]: 2- 8"3rd members:4.88 ratchet lockers,new setup kit, rear axle rebuild kit,diff armor
jerusry
Axles - Suspensions - Tires - Wheels
1
10-19-2015 05:28 PM
FS[GreatLakes]: Toyota collection part out
88sasturbotoy
Axles - Suspensions - Tires - Wheels
2
08-11-2015 01:56 AM
FS[SouthCent]: TX Third Gen UCA and LCA low miles Taco
KyleT
Axles - Suspensions - Tires - Wheels
1
07-21-2015 07:54 PM