p1300 code, engine won't start 1998 5vz
#23
Hey that screw's not supposed to be there. Camshaft position sensor screw. When I got the motor it was without timing cover, camshaft, and crankshaft sensors. I think the yahoo that got to the motor before me dropped it and it obviously went down and got trapped in the lower timing cover.
And those aren't supposed to be broken off.
I don't know maybe it was probably my fault. I shall not dwell on it. That screw put a few nicks in my timing belt, so my dear wife picked me up a new one tonight. Will report back.
And those aren't supposed to be broken off.
I don't know maybe it was probably my fault. I shall not dwell on it. That screw put a few nicks in my timing belt, so my dear wife picked me up a new one tonight. Will report back.
Last edited by vasinvictor; 03-20-2015 at 07:46 PM.
Thread
Thread Starter
Forum
Replies
Last Post
aciorba23
99+ Tundra, 00+ Sequoia, 98+ Land Cruiser/LX470
1
06-29-2015 04:18 PM