Hooking up the S-AFC
#1
Contributing Member
Thread Starter
Join Date: Jul 2002
Location: Tempe, AZ
Posts: 324
Likes: 0
Received 0 Likes
on
0 Posts
Hooking up the S-AFC
Alright guys. NOWHERE on the net is exact directions for connecting an S-AFC to my 96 Runner 4x4. What wire goes where? I doubt this is a tough install, but I don't have the right info.
Thanks!
Dan
Thanks!
Dan
#2
Registered User
Join Date: May 2002
Location: Southern MD USA
Posts: 1,539
Likes: 0
Received 0 Likes
on
0 Posts
I hear that Gadget has what you are looking for. You might want to contact him.
Gadget
www.GadgetOnline.com
Gadget
www.GadgetOnline.com
#4
Contributing Member
Thread Starter
Join Date: Jul 2002
Location: Tempe, AZ
Posts: 324
Likes: 0
Received 0 Likes
on
0 Posts
Well I am getting somewhere, but slowly.
So far the unit will turn on, and off correctly. It also display's throttle % correctly.
It is reading RPM's VERY low. It never goes above 1000 RPM's. What did I do wrong here?
Also, it isn't reading anything for air flow. Any ideas?
What sensor type do we use? hotwire? flap? pressure? karman?
Thanks guys. The good news is that the runner runs, so I can go to the bar now.
Dan
So far the unit will turn on, and off correctly. It also display's throttle % correctly.
It is reading RPM's VERY low. It never goes above 1000 RPM's. What did I do wrong here?
Also, it isn't reading anything for air flow. Any ideas?
What sensor type do we use? hotwire? flap? pressure? karman?
Thanks guys. The good news is that the runner runs, so I can go to the bar now.
Dan
Thread
Thread Starter
Forum
Replies
Last Post
smilen724
86-95 Trucks & 4Runners (Build-Up Section)
13
11-08-2015 04:11 PM