Searched and I'm not sure that I found the answer I was looking for.

Any how at the being of the year I kind of got my 4runner in a bad stituation and as I was attempting to back out of it (not a good idea). I damaged the center portion of my rear bumper.

Can that rear portion just be replaced or does the whole bumper need replacing (not planning on an offroad bumper at the moment)? Not sure what I'm going to do at the moment it will probable just get damage again.

 

You can just replace the center section. Check Ebay, they usually have a bunch on there.

 

Wormhole,

I have a factory rear bumper with all mounts and such sitting in my garage. Let me know if you are interested...send me a pm...

Regards,

BWJ

 

how bad is it? If you can live with it i would. That rear piece is about 200 bucks. maybe you can find it in a boneyard but the only one around here is lkq but they want 300 bucks for it.

 

Thanks, but my computer is being goofy and not allowing me to send a pm.

 

Or should I just say screw it and save up for a custom rear?

 

keep the banged up one on there 'till you can get a custom one built. they're pretty tax at around a thousand give or take..but well worth it. might want to check with steve at sonoransteel n see if he's still up for makin' one.

 

Screw it and I can make you one some day.

 

If you can fab one up similar to one that Brucets has made for a few people I'd be interested but it will be some day.

I want to get the rest of the work done to my 4runner first (locker and lights) then start saving a little more. I'm getting tried of living in apartment complexes (plus, I want a garage ).

 

The only bumper I can make/have jigs, templates for is the one that I have always made. If you want something other than that, I can't do it. Bumpers have a very low profit and are not really worth it for me.

 

That's understandable. We'll see what happens when the time comes. Don't want to get ahead of myself.



I've said screw it, i'll just bang out the backet so it's not crocked (spelled wrong I know) anymore and live with it.

 

I talked to a "new" fabricator shop/guy in CO a couple days ago about building me a rear 3rd gen bumper. He suggested that he builds what I want (we talked about you and everyone else thats built one) and then he contracts the templates/blueprints out to a full fledged commercial metal shop that can knock-out all the pieces needed in minutes. He said this can be done at a lesser cost and of coarse, reduce fab time significantly. Have you ever looked into this?

 

Yeah, it's a huge amount of up from money and you still have the problem of shipping the thing. In the last 2 years I have made 2 bumpers, so I am doing quite well without them. I am just not interested in making bumpers, they do not turn a very good profit. The bottom line is the bottom line, I can do better with other products.

 

I feel special.

 

Yeah you and Kent. I have one to "maybe" do in 2008. We'll see.