aalba92691's 1988 Pickup Build-Up Thread
#82
Registered User
Thread Starter
#83
Registered User
Thread Starter
#87
Registered User
he cut them..put in a block..then welded metal outside to box it all in...it's really VERY well built..check out the thread called Blazeland DIY weld up kit or something similar
#88
Registered User
Thread Starter
#89
Contributing Member
I'd have to paint them a different color or something... black is just too stock looking
not like canary yellow or grabber green but maybe silver or something
or go all out and get them stripped and dipped in chrome!
not like canary yellow or grabber green but maybe silver or something
or go all out and get them stripped and dipped in chrome!
Last edited by iamsuperbleeder; 11-19-2009 at 07:27 PM.
#92
#96
Registered User
holy cow 6 inches total. Hmm might look funny running 33 x 12.50s on factory front fenders. Even then with the 3 inch flared prerunner fenders from I think fiberworx????? they would be outside of the wells.
Whats the options on extending the rears to match?
Whats the options on extending the rears to match?
#97
Registered User
Thread Starter
You guys are killin' me.... I'm about to go out to the garage and start tearing my front end down.... I'd call in sick tomorrow but I already did that on monday and tuesday... otherwise I'd be on it...haha
#98
Registered User
Thread Starter
I think you could use some spacers... right now I have 1_1/2 inchers on my front wheels from All Pro. They have never given me any problems.. I'm probably going to move them to the rear after Blazeland is installed>>>
#99
Registered User
tell them you are sick of everybody hounding you to finish your truck and got to get it done to get them off you back. hehe.
#100
Registered User
covers 3 outta the six. should'nt look too bad.
found those fenders was wrong about fiberworx its Toyota Fiberglass.
http://toyotafiberglass.com/fenders.htm