ditchdrift's Freebie 1983 Build Up
#61
It actually increases the static compression ratio by quite alot, not decrease. I had the pistons fly cut about .3mm's so the compression should be in the 10.5:1 range. I used this calculator to figure it out.
http://www.csgnetwork.com/compcalc.html
http://www.csgnetwork.com/compcalc.html
#65
you can always tack it in place with superglue or jb weld. Then weld it.
Lucky for you it's not a pressure bearing part, but there is no way I see this happening on a DD. I have seen it happen to a drag car or two though. One the block the other the trans housing.
This is one reason of the many reasons to run a scatter shield. But not necc on a DD or a wheeler. I don't even think they even make one for any 22r transmissions.
Only thing I can think of is someone either had the motor or trans out at one point and did not have it fully lined up when torquing down the trans housing bolts.
P.S. Was the support brackets on the bottom of that block on both sides?
Lucky for you it's not a pressure bearing part, but there is no way I see this happening on a DD. I have seen it happen to a drag car or two though. One the block the other the trans housing.
This is one reason of the many reasons to run a scatter shield. But not necc on a DD or a wheeler. I don't even think they even make one for any 22r transmissions.
Only thing I can think of is someone either had the motor or trans out at one point and did not have it fully lined up when torquing down the trans housing bolts.
P.S. Was the support brackets on the bottom of that block on both sides?
Ive seen this before. No factory support brackets to the transmission or they ran broken motor mounts for to long. Either way I bet they drove it home!!
#66
Making more progress, i pieced together a timing chain kit with HD guides.
I cleaned up the head and did a damn good lap job on the valves, i have perfect sealing using a vaccum tester on the combustion chamber. Also smoothed out the runners and gasket matched intake and exhaust.
I cleaned up the head and did a damn good lap job on the valves, i have perfect sealing using a vaccum tester on the combustion chamber. Also smoothed out the runners and gasket matched intake and exhaust.
#70
#72
Thanks, its really not going to look that great. its mostly a budget build to be fun. Its going to get doublers, w56, 5.29's, locker, hi steer with hydro assist, 36" tsl's, rears up fronts, and 51" springs in the rear. Its actually just going to be a fun bomb around rig.
#74
Thread
Thread Starter
Forum
Replies
Last Post
Toys4parts
86-95 Trucks & 4Runners (Build-Up Section)
2
09-26-2015 01:56 PM
FS[PacNorWest]: 1987 4Runner SAS, 22RE, 5Spd, Dual Cases, etc
toyotasaurus
Vehicles - Trailers (Complete)
0
09-24-2015 03:30 PM