New Rear Bumper From T.G. With Optional Side Mounts
#41
Contributing Member
Thread Starter
Yes, mine is off centered by about the same amount. I'm going to have to grind a little off the left vertical piece to clearance it for my tail gate. It catches by a hair...just enough to scuff the paint on the tail gate.
If you POR-15 it you should probably strip the rattle can off and prep the bare metal with metal-ready, then 2 coat with POR-15 per instructions. That stuff works great as long as you do the prep work right. Otherwise, it'll peel off in sheets. i did my frame with it and it looks pretty good....but it does need a top coat if it's in direct sun light.
I noticed you had trouble painting the same areas I did on mine! those are a PITA to get covered well.
Looks good though. I'll have to get some pictures of mine for you to see.
If you POR-15 it you should probably strip the rattle can off and prep the bare metal with metal-ready, then 2 coat with POR-15 per instructions. That stuff works great as long as you do the prep work right. Otherwise, it'll peel off in sheets. i did my frame with it and it looks pretty good....but it does need a top coat if it's in direct sun light.
I noticed you had trouble painting the same areas I did on mine! those are a PITA to get covered well.
Looks good though. I'll have to get some pictures of mine for you to see.
#43
Registered User
When you do the POR15 you have to have a coating over the top of it, because it's UV sensitive, so it fades and will flake off over time.
i did POR15 on my truck's rear bumper last year. it was shiny for about a week, and got dull very fast.
i did POR15 on my truck's rear bumper last year. it was shiny for about a week, and got dull very fast.
#44
Contributing Member
Thread Starter
Is that with the engine paint kit?
#45
Registered User
Join Date: Jul 2009
Location: Eastern NC
Posts: 832
Likes: 0
Received 0 Likes
on
0 Posts
Thanks for the pics, That is a sweet looking pan, My first HD was a 76 shovel that I built out of few budies garages when I was 16, litteraly duct tape, shoe goe, and wire were holding it together. Wish I had never sold it. My funest HD yet was a 91 classic. Retired cop bike, tranny was shot so I put a baker 6 speedin, some local motor cops saw me on it all the time took me under their wing and taught me to actually ride it. I loved it because I did not care if it went down in low speed playing.
Bumper looks great,
Well off to make some money.
Later.
Bumper looks great,
Well off to make some money.
Later.
#46
Registered User
Thread
Thread Starter
Forum
Replies
Last Post
RedRunner_87
95.5-2004 Tacomas & 96-2002 4Runners (Build-Up Section)
84
06-01-2021 01:51 PM
WTB[WestCanada]: 1989 4runner stock front bumper and other items
lledwod
Items Wanted
1
08-30-2016 01:03 PM
icentropy
86-95 Trucks & 4Runners
10
07-11-2015 07:21 AM
Vargntucson
95.5-2004 Tacomas & 96-2002 4Runners
0
07-04-2015 12:15 PM