ARB snorkel... How do I make it work with an EFI toy?
#21
Contributing Member
Hey guys. I've been looking at the snorkle idea myself (just going to run it under the fender). But so far, I haven't found a place that would just sell me the ARB snorkel cap piece (top piece where the air comes into the snorkel). The rest I'll build myself. Any suggestions?
#23
Contributing Member
ARB Web Site
I called several places who sold the snorkel, and for each one it was all or nothing. I've searched for the actual ARB website, and either I'm blind or just stupid, but I couldn't find it at the time so I could contact them directly.
Do you know what it is?
Shannon
'88 Runner
Haines, Alaska
Do you know what it is?
Shannon
'88 Runner
Haines, Alaska
#24
Registered User
Join Date: Dec 2002
Location: Idaho
Posts: 4,655
Likes: 0
Received 0 Likes
on
0 Posts
#25
Contributing Member
iTrader: (3)
I'll be connecting the ARB snorkel tube to the end of my in-fender snorkel:
- http://www.4crawler.com/4x4/CheapTri...shtml#Phase-II
The sizes match up perfect, existing tube will be cut off just after the pair of 90 elbows:
I have my air box on the passenger side (using a RHD snorkel), but the same setup could work for a driver's side box.
- http://www.4crawler.com/4x4/CheapTri...shtml#Phase-II
The sizes match up perfect, existing tube will be cut off just after the pair of 90 elbows:
I have my air box on the passenger side (using a RHD snorkel), but the same setup could work for a driver's side box.
Last edited by 4Crawler; 11-03-2006 at 01:15 PM.
#26
Contributing Member
Talked to ARB...
Thanks for the link. I talked to a guy there at ARB and the 3" cap is around $55, and the 3.5 inch is $65. This might be a spring time job for me. Tomorrow I'm doing the fuel filter, then I want to take a break from working on it for a while.
Thread
Thread Starter
Forum
Replies
Last Post