92 TOY's 22re / crapped out / gotta start somewhere / thread
#2581
YotaTech Milestone-Two Millionth Post
Thread Starter
#2585
YotaTech Milestone-Two Millionth Post
Thread Starter
OCD can be quite helpful sometimes.
went to my box of parts from the tear-down and there it was laying there (the used one) and so that is what is going on there
went to my box of parts from the tear-down and there it was laying there (the used one) and so that is what is going on there
#2586
YotaTech Milestone-Two Millionth Post
Thread Starter
Ted also responded.....he's awesome.
he said, individually would be a tough one to find there and suggested getting some bulk high-temp gasket material and fabbing my own.
he said, individually would be a tough one to find there and suggested getting some bulk high-temp gasket material and fabbing my own.
#2590
YotaTech Milestone-Two Millionth Post
Thread Starter
thank you Mark.
OK...getting my butt kicked trying to line up with that REED valve.........grrrrrrrrrrrrrr
over an hour of struggling so far and still can't get it to line up.....grrrrrrrrrr
taking a much needed break.
PICS
No matter what amount of prying and wedging i do, i can't get the bolts to hit the holes......i have the valve itself loose and can pry around the tube only sooooo much.
OK...getting my butt kicked trying to line up with that REED valve.........grrrrrrrrrrrrrr
over an hour of struggling so far and still can't get it to line up.....grrrrrrrrrr
taking a much needed break.
PICS
No matter what amount of prying and wedging i do, i can't get the bolts to hit the holes......i have the valve itself loose and can pry around the tube only sooooo much.
#2593
Registered User
Just gotta loosen some stuff up and wiggle about a bit and she'll go. Try standing on you left foot while balancing a cup of coffee on your right knee and (this is important) turn the screw with you left hand using a wrench made out of tin foil.
#2594
YotaTech Milestone-Two Millionth Post
Thread Starter
what mounts? where the valve hooks onto the lower intake? already done.
will regroup and try again in a few.....maybe the toyota fairy put it back together for me while i'm sitting here......cuz actually, i went from about an inch and a half off to almost dead on...
#2596
YotaTech Milestone-Two Millionth Post
Thread Starter
alerady done, but ya forgot about the smoke hanging out of the mouth and the camera in the other hand.....it looked like i was working on my truck with chop-sticks because i had the 4 foot breaker bar in one hand and a crow bar in the other and the a block of wood, a mirror (worthless) and vice grips.
it's not that i'm not trying hard enough.....might be i'm trying too hard.
"Luke , don't force it.........."
#2597
YotaTech Milestone-Two Millionth Post
Thread Starter
#2599
YotaTech Milestone-Two Millionth Post
Thread Starter