3vze How many miles?
#63
Contributing Member
Join Date: Jul 2006
Location: Humboldt County, CA
Posts: 284
Likes: 0
Received 0 Likes
on
0 Posts
just turnd 185,000 miles. head gasket recall done at approx 65,000. timing belt and water pump done by me at approx 145,000. no major problems. i use mostly castrol 20-50 i change it when i remember to. which reminds me i think i need to, it's been a while.
#64
Registered User
Join Date: Jul 2006
Location: INDIANA
Posts: 2,149
Likes: 0
Received 0 Likes
on
0 Posts
162k miles and no problems so far T/C was replaced about 7000 miles ago small leak on valve cover.
about to do a oil change going to try the castrol GTX also need to change plugs &wires and 02 sensor soon.
about to do a oil change going to try the castrol GTX also need to change plugs &wires and 02 sensor soon.
#65
Registered User
Join Date: Feb 2010
Location: Spring, TX
Posts: 31
Likes: 0
Received 0 Likes
on
0 Posts
91 Pickup 4x4 318,000 miles no major motor work a/c blows cold original Head gaskets. rebuilt rear axle, new leaf springs, rebuilt front end control arm bushings, ball joints, wheel bearings, tie rods at 310,000 has several oil leaks needs new timing belt, dealer pushing me to do the HG recall said it would save $300.00 on the timing belt.
#66
Contributing Member
91 Pickup 4x4 318,000 miles no major motor work a/c blows cold original Head gaskets. rebuilt rear axle, new leaf springs, rebuilt front end control arm bushings, ball joints, wheel bearings, tie rods at 310,000 has several oil leaks needs new timing belt, dealer pushing me to do the HG recall said it would save $300.00 on the timing belt.
#67
Registered User
Join Date: Feb 2010
Location: Spring, TX
Posts: 31
Likes: 0
Received 0 Likes
on
0 Posts
They did not I brought the truck in for the steering link recall and the service advisor called me about the HG recall, I have always be a proponent of the "if it aint broke don’t fix it " saying but I am thinking of taking advantage of the discount in labor. My main concern is what problems they might uncover when they pull the heads off.
#69
Bought a '91 4runner for my daughter and it 'appears' to have a head-gasket problem. The local dealer verified that this job has been 'done' on this truck. I'm so frustrated I could spit !
She overheats at the drop of a hat with a new radiator and a new thermostat (drilled at 12-clock to pass air) and it gets hot easy. Also, when completely cooled down the next morning, removing the radiator cap caused some pressurized gas to escape. This doesn't seem normal to me. could the dealer who 'fixed' this on recall have just thrown in more of the 'bad' gaskets ??
Which gaskets do I need when doing this job ??? Rock ? I want the best in fact I'd like solid copper like a racer uses, but I havn't found any...
Thanks,
Brad
She overheats at the drop of a hat with a new radiator and a new thermostat (drilled at 12-clock to pass air) and it gets hot easy. Also, when completely cooled down the next morning, removing the radiator cap caused some pressurized gas to escape. This doesn't seem normal to me. could the dealer who 'fixed' this on recall have just thrown in more of the 'bad' gaskets ??
Which gaskets do I need when doing this job ??? Rock ? I want the best in fact I'd like solid copper like a racer uses, but I havn't found any...
Thanks,
Brad
#70
Registered User
Join Date: Jun 2009
Location: delavan wi
Posts: 35
Likes: 0
Received 0 Likes
on
0 Posts
176 n change oil changed every 3000 from new mexico women owned /pampered then drove from nm to wisconsin in between started missing bad n she sold to me very clean for 100$ havent fixed it yet think burned valve not sure as antifreze stays same as well as oil plus very recent tune up by me all new spark plugs wire rotor cap.plus fuel pump went out n i matched up chevy pump
#71
Registered User
Join Date: Jun 2009
Location: delavan wi
Posts: 35
Likes: 0
Received 0 Likes
on
0 Posts
quick question about the hg recall how would i find out if mine is exceptable/still up for grabs if time hasnt run out ??etc.... sorry to redirect ne 1 with input please give me direction ty
#72
Oh boy! Here we go fellas!
Just to get it out of the way, and onto the record, mine went 218,000 miles before blowing the original head gasket. No other major engine work 'till around 224,000miles when I had to tear it down to replace a cracked piston. Nothing since with around 230,000 miles now. And such is not as uncommon as is popularly believed.
Do I ever have a thread for you on the 22RE vs. 3VZE reliability debate. One of my finest hours...
Enjoy!
https://www.yotatech.com/forums/f116...-valve-222710/
Just to get it out of the way, and onto the record, mine went 218,000 miles before blowing the original head gasket. No other major engine work 'till around 224,000miles when I had to tear it down to replace a cracked piston. Nothing since with around 230,000 miles now. And such is not as uncommon as is popularly believed.
Do I ever have a thread for you on the 22RE vs. 3VZE reliability debate. One of my finest hours...
Enjoy!
https://www.yotatech.com/forums/f116...-valve-222710/
#73
Registered User
Join Date: Jun 2009
Location: delavan wi
Posts: 35
Likes: 0
Received 0 Likes
on
0 Posts
hippy when ever i see your post i cant help but being glued to the screen to read every detail u r truely pasoniate n well informed as far as i can tell....as r many other here at yt
#74
Registered User
1988 4Runner, over 234,xxx miles. Don't know how many P.O. there were on this vehicle. Does not qualify for HG recall (it's got the good ones). Owned it over 3 yrs now and have an O2 sensor into it along with a recent (this summer) water pump, fuel pump, timing belt replacement. Other than a tune up every year, timing light and timely oil changes, nothing major to this 3.0L motor.
#75
Registered User
iTrader: (3)
Since we are indeed posting to this 7-8 year old thread and I missed it on the first go-round... My previous 95 t4r v6 had 183k with on 1 timing belt/water pump before I wrecked it. My current 3vze has 204k on it, and only ever timing belts and valve adjustment. Gets 15-16 mpg regularly on 87 gas. This is my 2nd 3vze and I will purchase another. Both have had head gaskets done, 1 under warranty. They are the most reliable motor I've ever had the pleasure of owning. Not so pleasurable to work on in the rare case it's necessary, but I know my way around by now.
The following users liked this post:
drpete82 (07-16-2023)
#77
I'm proud to have established such a following, or atleast gained a follower, here. Maybe I really can make a difference? Love me, or hate me though? That's up to each individual to choose. Either way, there's no stopping me now. I'm on a roll!