3.0 is super loud and shakes....what the hell
#21
ok went out for a drive tonight and heard some more nioses coming from my rear end....when i reversed out of my drive way and through it into drive (auto) i heard a ding come from the rear end...sounded like a pipe hit the ground...and as i drove i heard it again and again...only when i hit the gas...not all the time but if i was just idling around town and hit the gas it would do it...i dunno what do you guys think...another thing...is it my rear axle...i have a blown drivers side axle seal...if it is then i might swap another axle in...maybe one from a taco with an e-locker...prolly gonna have to look at some junk yards
#22
Registered User
ok went out for a drive tonight and heard some more nioses coming from my rear end....when i reversed out of my drive way and through it into drive (auto) i heard a ding come from the rear end...sounded like a pipe hit the ground...and as i drove i heard it again and again...only when i hit the gas...not all the time but if i was just idling around town and hit the gas it would do it...i dunno what do you guys think...another thing...is it my rear axle...i have a blown drivers side axle seal...if it is then i might swap another axle in...maybe one from a taco with an e-locker...prolly gonna have to look at some junk yards
#24
Registered User
Always change them both. I would not just do one. If it is making that ding noise, it must be really bad. I would change it ASAP to avoid it braking on you as you are driving, and you don't want that to happend. Could do alot of damage..........................
Last edited by keithguts; 06-28-2007 at 05:13 PM.
#26
Registered User
I got them replaced by the shop I always use. I could not belive how smooth the ride was after doing it. It was like getting a new rig. It drove me nuts for quite some time, but this yotatech lead me to the right thing and told me it was the u-joints., so I went for it, and it fixed it. YOTATECH ROCKS in my book. I will go nowhere else for info on my yota but here.
Last edited by keithguts; 06-28-2007 at 05:38 PM.
#29
Registered User
#30
ok so i picked up some u-joints today after hearing a loud clunk and my rear ujoint is totsally gone...anyway i got my bolts out of my driveshaft now how do i get it out? big hammer and pound it out? or is there an easier way?
Thread
Thread Starter
Forum
Replies
Last Post