22re valve cover torque specs
11-19-2007 | 12:29 PM
#2
Registered User
Joined: Nov 2007
Posts: 598
Likes: 3
From: seattle WA
i was told by the dealer (when i bought new grommets and half moons) to add some silicone to the moons, and tighten the cover untill those 4 rubber grommets just start to squish. meaning < 10ftlbs
but hey, just call up the Dealer and ask, they are always helpful w/me, they even give me printouts of the stuff i buy, and how it goes into the truck.
but hey, just call up the Dealer and ask, they are always helpful w/me, they even give me printouts of the stuff i buy, and how it goes into the truck.
11-19-2007 | 12:34 PM
#3
Registered User
Joined: Jan 2006
Posts: 684
Likes: 2
From: North Georgia
X2, its all about the "squish" of the grommet. And remember to torque about half a turn at a time in an X pattern. I Try to have NEW half moons and grommets when I put it back on, and just apply a little daub of RTV to the corners of the half moons. More than that and it gets messy when you disassemble next time.
i was told by the dealer (when i bought new grommets and half moons) to add some silicone to the moons, and tighten the cover untill those 4 rubber grommets just start to squish. meaning < 10ftlbs
but hey, just call up the Dealer and ask, they are always helpful w/me, they even give me printouts of the stuff i buy, and how it goes into the truck.
but hey, just call up the Dealer and ask, they are always helpful w/me, they even give me printouts of the stuff i buy, and how it goes into the truck.
Thread
Thread Starter
Forum
Replies
Last Post
the1998sr5
95.5-2004 Tacomas & 96-2002 4Runners
15
07-14-2020 08:35 PM
GreatLakesGuy
The Classifieds GraveYard
8
09-04-2015 09:27 AM
